|
Re: Clutch assembly or transmission?
Quote:
|
Originally Posted by Mikelb
I'm just gonna ignore all the above posts and do my best to answer the original question...
I would lean towards the throwout bearing. I'm not sure why they do this, but my car does it as well... when I'm pressing the clutch, I do not havethe rattle, but when I let off the clutch it rattles.
This has happened on two TOBs. That is the diagnoses both times. It doesn't really seem to affect performance (never mind that my tranny just self-destructed due to a faulty TOB and clutch fork)
|
Did the noise get louder while you were driving?
__________________
1998 Eclipse GSX
6 Bolt swap
MHI Big 16g
FP Race Manifold
Apex'i N1 Cat-back
Apex'i N1 Downpipe
Walbro 255 fuel pump
GReddy Type S BOV
Turbo XS Boost Controller
Balance Shaft Elimininator
ACT 2600
RRE 11lb No Name Flywheel
Prothane Motor Mounts
Tokico Illuminas Advanced Handling Kit
RRE Front and Rear strut tower bars
RMDSM Front and Rear Sway Bars
TRE Stage 2 Tranny
ARP Head Studs, Main Studs, Rod bolts
|