[BlackZodiac]

So according to those wiring diagrams it does go to the BCM... are the 03 and 96-99 the same with that circuit?

If so then it makes a whole lot of sense.
I should be able to check continuity from the horn button to the clockspring, clockspring to the BCM input and then check BCM output for power. If there's a signal in, but none out then it could be the BCM.

1thunder: Did they change the wiring in the 03's? Does it not go to the BCM like in the diagrams RIP supplied? What is the location of the Front Control module? I'm not sure where cavity 19 is. I know the BCM is in the drivers kick... It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. Any more info?


Once I have testing locations then I should be set. I'll backtrack through the system until I find the dead link. Shouldn't be too difficult.

Thanks for the help so far.