[transgta]

Its a little messy start on one side such as front or back after removing bolts then go down sides one at a time on each side eventually the front will start to drop a little letting some out.Set your pan there then slowly just keep going til just a couple left by this time a lot should have came out then just hold one hand up on pan take last couple out slowly bring down. My yukon has a drain plug but my 01 ford does not check for that first.The filter is easy just make sure the little ruber seal comes out when it comes out just look at new one youll get what im talking bout.Your gasket should be a reuseable one its ruber with wire in it and it will say on it reuse make sure it goes back on just like comes off.Your fluid should be mercon 5 call dealer to make sure USE WHAT IT CALLS FOR .Going back up hand tighten all then start a z pattern back and forth. Its not hard just dont get in a hurryDAVE