[IsuRod1999]

Hello together,

is there anyone with an idea for my problem?

I picked the diagnostic steps out of an Isuzu Repair Manual.
But at the point I am it only told that I have to go to a dealer!

The book said there has to be a supply voltage of about 5 V on the wire to the crankshaft position sensor.
As far as I know the PCM supplies the sensor with the voltage. Is it possible, that my PCM goes wrong??

Or is it more likely a faulty sensor, which has to be cleaned or changed.
Is a defect crankshaft position sensor a common problem with Isuzu Rodeos?

Please be sorry for my bad English, but my first language is German. Would be thankful for any advice.

Robert