Quote:
|
Originally Posted by VELEZ
Im going for swapping a manual trans on my 200sx se-r.
I know it requires many changes as flywheel, starter, pedals, some brackets etc..
|
flywheel, clutch, pressure plate, pilot bearing, throwout bearing, shift linkage, shifter/bracket/console bezel, slave cylinder, master cylinder, clutch pedal, clutch pedal bracket, trimmed brake pedal, starter, clutch lines, and i may be forgetting something, but i dont think so.
Quote:
|
Will the auto axles fit on the manual tranny?
|
probably not, but im not sure
Quote:
|
Do i have to replace the crossmember?
|
im pretty sure you dont...
but this is better posted in the sentra/200sx forum at the bottom of the nissan page