[atfdmike]

1995 Isuzu Truck Trooper (4 Door) V6-3165cc 3.2L SOHC (6VD1)

Vehicle Level Accessories and Optional Equipment Keyless Entry Service and Repair Service and Repair

1995-1996 Trooper (with optional keyless entry system)

1997 Trooper (with factory-installed system)

Programming the Transmitter

NOTE
The system uses a stacking-type memory that accepts up to four transmitters. If you program a fifth transmitter, the memory for the first transmitter is cleared, and it will no longer work.

To clear a lost or stolen transmitter from the system's memory, program a transmitter four times. This will remove the missing transmitter from memory, since only four transmitter codes can be accepted.

Another way to clear a lost or stolen transmitter is to erase all transmitter codes and then reprogram them. Refer to the security system owner's manual.

1. Remove the driver's side lower dashboard panel.
2. Turn the ignition switch ON (II).

1. Press and hold the green programming button on the side of the control unit with a pen or pencil until the exterior lights come on. The lights will come on for five seconds. (Steps 3 and 4 must be done within 5 seconds of each other.)
2. Press and release the top button on the transmitter.
3. Check that the LED goes out, the siren chirps once, and the front marker lights flash to confirm that the transmitter's code was accepted by the control unit.
4. If you have other transmitters to program, repeat step 3 for each one.