[my99cavy]

Fig. 5: Remove the window regulator switch housing by gently prying up, starting at the front

1. Detach all connectors from the switch housing.
2. Remove the door inside handle cup.
3. Remove the push pin from the door trim panel upper front extension and remove the screw.
4. Remove the lower self-tapping screw retaining the door trim panel to the door inner panel.

See Figures 6, 7 and 8
Fig. 6: Detach the switch housing electrical connector and remove the housing


Fig. 7: Remove the door inside handle cup


Fig. 8: Remove the screws from the door panel in the front and on the upper extension

1. On Grand Marquis, pry up the screw covers from the door pull handle and remove the screws and handle.
2. Lift the door panel upward and snap out the panel.

See Figures 9 and 10
Fig. 9: There are also retaining screws located in the map pocket as well as ...


Fig. 10: ... along the bottom edge of the door panel

1. Disconnect the necessary wire harnesses and remove the panel.