[Heep]

The starter motor isn't really under the battery, it's underneath the intake manifold towards the battery. It should be directly under the manifold (in the back of the engine), it's most likely dark rust colored, a cylinder maybe 3 inches in diameter. Here are the removal steps:

1. Disconnect the negative cable from the battery.

2. If equipped with an automatic transmission, remove the kickdown cable routing bracket from the engine block.

3. Disconnect the starter cable and push-on connector from the starter solenoid B and S terminals. (Disconnect the connector at the solenoid S terminal by grasping it, depressing the plastic tab, and pulling the connector straight off to prevent damage to the connector and terminal)

4. Remove the upper and lower starter motor mounting bolts. Lift the starter motor up and remove it from the engine.

5. Installation is the reverse of the removal steps. Tighten the mounting bolts securely.