|
Re: Good Gasket Remover?
anything with aluminum oxide is very bad to use on a gasket surface, unless you plan on hot tanking it after you get done.
Most abrasives that are used in die grinders, angle grinders, drills etc have aluminum oxide in them. The AO will not get stopped by the oil filter and will destroy your bearings.
All the manufacturers have had TSB's on this for a long time
A solvent to loosen it up, followed by a razor and a wet stone is the best option, although it can be time consuming
__________________
life begins at 10psi of boost
Three turbo'd motorcycles and counting.
|