Ok, so I went to a junkyard, got one that they said MAY work, so because they werent sure I had them write down on the receipt that they will refund my money if it didnt work. So I get home and install it, and nope.... the NO BUS was there right away, without even a start. So I started thinking, heat makes this happen. So me being the tweek fabricator that I am I built a 12volt fan with a toggle switch ran under my dash so I could start and stop it from the drivers seat, into the front plate of my original ecm. Took awhile, but I finally got it all to work. Started the D, let it idle for awhile and KAPOOT died again. So I took the used junkyard ECM back to the junkyard, got my money back, and I ordered a remanufactured one from ECUDIRECT.COM ....they sell them for around 400, flashed already and shipped. This is my absolute effort on this POS. If this doesnt fix it im calling the bank and telling them they can come and get it. Im already several months behind anyway in the payment trying to get it fixed. So its a voluntary repo if this new computer doesnt fix it.
