|
Re: Need drawing of steering column to replace ignition (key assemb.)
Disconnect battery, wait at least 1 minute for airbag system to de-energize, remove trim from column(a few screws underneath), disconnect key warning switch wiring(small),turn tumber to run, insert 1/8" rod into hole on underside, slide tumbler out.
Installation is the reverse of removal, turn tumbler to run, hold the pin in as you push the assembly into the column, making sure it's fully seated.
That is if you can get it to turn to run (I assume you can)
If you cannot turn it to run, send me a PM because the procedure is a bit more involved, requiring more parts. It's something I don't recommend be done by anyone but a professional, or someone VERY mechanically inclined.
|