[jcb18]

I have the FAQ page copied and pasted into a Word document so I'd have access to it from my laptop when I'm out in my garage. I can email it to you if you need it urgently. Send me your email address via private message and I'll send it over. I guess if anybody else needs it I can send it.

Also, the IMG that typically cracks is the lower one, on the drivers's side. Of course, replace both sides as long as you have the plenum raised. Instructions are in the FAQ and make sure to use the revised torque specs (13 lb-ft I think, but 2x check the FAQ). The PCV grommet is the rubber piece that allows the PCV valve to stay snugly attached to the crankcase but easily removable for maintenance. The PCV valve and grommet are located under the engine cover on the driver's side on the top of the front half of the crankcase. It's a brownish orange plastic piece with a vacuum hose running to the throttle body. You should be able to find the rest of your questions in the FAQ.

-Justin