[musclecah]

Just wanted to let you guys know I figured it out... they are the right parts... they should supply a pic with the new bracket and two extra bolts that are needed. they are the same size bolts as the tranny pan bolts... the new bracket bolts on in line with the same corner t-pan bolt as the old, but above it... when you take the corner pan bolt out to remove the old bracket, stick a nail or a p-head up into the hole and you'll see it continues through into another hole in the edge of the casting above it... same with the other hole that the new bracket lines up with... the new bracket rests on top of the casting and the bolts are installed from above... little tough on the knuckles but doable... the holes need to be cleaned out real good too since their full of crap and haven't been used before... I ended up stripping one and had to run one bolt up through the tranny pan hole below and put a nut on top to secure the bracket... I'll post a pick of the old and new braket asap... Chris-cah.