[Shinji]

Hello everyone,

Well I finally got the new Turbo back from Greddy (Sent it back 3 times only to find out there was a machining issue in the housing.) and it works great however I was looking at my intake pipe near the throttle body and realized there is no place for a BOV install.

Now obvious I am going to need one if I am going to protect my investment a little more then what the wastegate does.

From what I have read both here and other place's all I need to do it tig weild the flange into the intake pipe going to my throttle body and drill a hole correct?

Now also I am not sure where I can T into for a Vacuum line to connect to the BOV or if there is a certain vacuum line I can use.

I am installing this on a 99 Honda Civic EX (D16Y8), any help would be great as google searching has so far not really explained anything for a Civic.

I did find that Eclispe install directions helpful for a "general" installation location.

Thanks in advance.