Quote:
|
Originally Posted by spartfaithful
I recently had a driver side rear caliper that was stuck. I changed the caliper and proceeded to bleed the brakes manually. I initially only bled the caliper that I changed and there was a significant lack of pressure. I then proceeded to bleed all the brakes. So I started with the rear passenger and that one bled fine. When I did the next caliper (rear driver) all of a sudden no brake fluid was coming out of the bleeder screw.
Why would this happen?
Now I have almost no prake pedal pressure.
Please help
|
You tripped the equilizer valve over center. The block where the front and rear lines run threw under master cylinder. There is a plunger in it under the rubber boot if out you can push it in but if pushed in.
Go to the other end and open bleeder and see if it trips back.
They nake a holding too to hold it centered while bleeding.
If you have ABS brakes they may require a tech 2 scanner to bleed the ABS system.
MT