|
bent valves
ok so today i decided to start stripping my engine, and remove the head i found 2 bent valves on cyl number 3, my uncle kept telling me to try to put in new valves, but i think it would be too hard, so i'm gonna start looking for a new head, but i was thinking this. 1g head comes with bigger intake ports i'm not sure about the exhaust ports, i was like, would a 1g head bolt on to a 2g block(bottom part, where the cylinders are)? would it be a good idea to use a 1g head with 1g intake, 1g TB and 2g elbow?i took some pics too, i'll upload them later, anything else you guys recomend i should do now while everything is out?
__________________
 -MODS-
Autometer Boost,Oil Presure,And Water Temperature Gauges./Geddy Turbo Tmer/Eibach Sportline Springs Matched With Adjustable Iluminas 4 Corners/Konig 18" On Nitto Extreme 555/ACT 2100 PP with Street Disc/Extended Push Rod/Urethane Motor Mounts/XS Power FMIC. 28X10.5X3.5/Greedy Type RS BOV/ evo3 16g Turbo/MBC At 18PSI/Bian Crower 272 cams/SAFC2 With 510cc Injectors/Walbro 190 FP/
1/4 mile=14.3@103MPH
|