[Talont28]

umm...in all honesty the swap is cake...i did it on my 96 talon tsi.. and only took about 3 days
here are the parts you will need this is for a fwd..if your going to do it on an awd you will need a new xfer case drive shaft and rearend...
1 tranney
2. clutch and flywheel of course
3. new flywheel bolts...the auto are just to short
4.pedals
5. shifter with all the cables
6 master and slave cylinder
7. a clutch line goes from the master to the slave cylinder i recomend slowboy for this 100 bucks for the ss line but it will make everthing so much easyer..
the only wiring part you will half to do is the inhibiter switch you half to cross one wire to activate the starter when you turn the key...

putting all the stuff together isnt bad when you go to put the pedals in the holes for the clutch pedal will already be there same for the master cylinder..the only cutting you will half to do is cutting a hole in the fire wall for the master cylinder... but its dimpled in on the fire wall...its cake...the rest is easy simple tareing off the old parts and putting on the new...


if you have any questions or anything let me aim talont28





But if you were talking about going standard to auto..thats a whole diffrent story you will need the auto ecu...and the harness...it will be a nightmare...

Jesse