thanks. I need to start working on the brakes again. Once I have the hubs and hub mounts for the wheels done, I should be pouring some more RTV. Maybe By next thursday I'll have a pair of heads and some disc brakes. I should make some smaller rotors for the rear.....time will tell though. lol I want this to look as realistic as possible, which means smaller rotors in the rear. I'll also have to hack up the chassis plate, reworking the trans tunnel, as well as reworking the rear wheel tubs and complete rear half of the chassis plate will have to be reworked for the 11" wheels and the four link. I'm also planning on adding brass axle tubes. I feel that this will help to support the added weight that the extra parts are going to add, albeit not much, but it will allow for added detail around the ends of the tubes by soldering the pieces in place instead of relying on super-glue. Stay tuned for frequent updates. I've got a lot of ground to cover before I begin Cal III on June 2