[busboy4]

Hi Karl
yeah those things should just pull right out. I know corrosion and dirt etc. make them stick. I will tell you they deform very easily if you tap on them with a hammer etc. With that said you may have to sacrifice it to get it out. I used a 2x4 once as a "cushion" and rapped the other side. I bent it slightly but it did come out.
On another note. If you have had much vibration on that side, I would encourage you to look carefully at the hub while it is pressed out. On my 96 the hub bolt had loosened somewhat, and in addition to the bearing being shot, the hub had worn under the vibration and remained somewhat loose after re-assembly. When we pressed it back out, there was obvious wear on the hub "shaft", so I replaced it too. Unfortunately that added $100.

Good Luck