|
Re: Here was my fix for the balance shaft plug
The center actually bumps in a little. I pre fit it with the bolts in place and then took a plastic hammer and hit the plate in!!!! to form the round surface (indent a little). You could use a few washers to build up past the seal but i did not want to. Thats why i made the plate indent.
__________________
Current Cars
2006 Eclipse GT 6 speed MT (V6 3.8), mods so far- S Tech Springs, after market 18's, 2012 headlight Conversion, Greddy cat back exhaust, CAI, RRE Headers, Polyurethane Motor Mounts, NX Nitrous kit at 100 shot for now, RPM Window Switch, Triple Pod.
2003 Grand AM GT - official beater car for the winter lol
----------------------------------------------------
95 TSI AWD [email protected] (T-25)
Now fully Modded engine with 3,560 miles on it.SOLD
|