Well the side door doesn't even get open at all, it just cracks the seal and pops out a little, the next motion I think then should be where the motor takes over and opens it out, then back. How does one look or adjust the alignment on the door? I lubed the rollers and latches with garage door lube that is the dry type so it don't collect dust/dirt. It seemed to help and yes it is colder climate here in Wisconsin. If I knew what to align I will do that. thanks.
The fog lamps, I will read that again but I have also turned the headlamp switch to lights and tried to pull out but it don't pull out at all, maybe 1/16 of inch but that didn't do anything with the fog lights to turn them on. I will look at it tonight again and reply tomorrow. thanks!!
Quote:
|
Originally Posted by slantsixness
Your door issue is an alignment problem or lubrication on both the side door and rear gate. Any slight restriction in movement will cause these doors to close when half open, or open if it meets restriction in movement. The alignment isn't too tricky to do. The grease sometimes gets stiff in cold climates and will cause this to happen too.
As to the Fog light scenario...  ...I'm not aware of fog lights that activate like that from Chrysler. usually, you either pull the light switch out, after turning the lights on (as in "Pull" like you were trying to pull the knob off, not the hi-beam lever "pull") That might be what you're doing wrong?
Hope I helped,
Tom |