Some work on fuel connectors (Sakatsu) and line (brass rod)
Some spring flowers
Sakatsu connectors was primed (Gunze Mr Hobby metal primer) and painted with transparent red and blue:
Working steps for electrical cords:
Alternator turned and decaled (home printed) I had a trouble: I crop this little decals over the ink (sealed with TS) and water melt colors. Well it's 3mm diam, at naked eye it's ok: I noticed it by picts
Pulleye assy: I need to touch up or remake with elecrical tape the belt
The air duct assembly is the most visible part in this engine: I tried to detail that with some home-maded decals for air mass sensor etc.
Also air duct, like in the real car, was remaded with rod and a surgical tape wrapped around
