[Blackcrow64]

Ok, so I took off some more vaccum lines tonight, tore my starter apart and cleaned it out. But, I didn't see any brushes in there like I was told. All there was were a bunch of magnets and some heavy center piece that had these plates all over it? Anyways, I cleaned it up and what not and put it back together and reinstalled it.

I took out my charcoal canister but as far as I can tell it does nothing... There are two nipples on the top of it and there was a line running to the one but the other had nothing on it. So, I just took it out for the moment because I'm still unsure about it.

I was reading my manual and am still trying to figure out what the clutch damper does? Is it a necessary part? I still wanna find a way to run an AN line from the slave cylinder to the master cylinder to clean it up and because of that "sludge" in the lines.

I was tearing the front end apart tonight too, preparing for my FMIC to be put on and I was wondering if there needed to be some type od bumper support for the bumper cover or not. I've heard yes and no but I don't really wanna cut the bumper support up if its not needed at all.

Am I gonna get any feedback in this thread at all? lol