Quote:
|
Originally Posted by zanthrax
Thanks for the comments and tips.
I ussually get better results on my windowrubbers. And I allways do them by brush, no masking.
I just used a worn out brush on this one and the lines of the rubbers are a bit fuzzy on this kit.
I tried masking tape once but paint kept creaping under it, especially where the tape was bent around corners.
Does masking with BMF work?
|
Masking tape work wery well, only use Tamiya kind on the edges, this kind is soft, conformable, and thin. Place the tape , press it carefully and cut with a sharp knife along edges, so peel tape in excess and spray or brush. Another way is outlining edges with a flrxible 1mm wide tape strip and fill the rest.
Well at least fi you don't like mask you'll outline edges with a permanent black fine felt anf fill all with the brush
