Sorry for this newbie question but I don't want to mess this up.
I'm about to put some new senatrac shocks on my 2002 Rodeo but for some reason I'm having a brain fart as to the hardware that comes with these shocks and where it goes.
I have two rubber gromments, 2 silver washers and one nut.
Do I use all this hardware for the top (putting one set on each site of the bracket attached to the frame) or is one of the rubber gromments and washers supposed to be used on the lower end. It seems like if I used all this hardware on the top, there would be no room to bolt it down.
I'm going to have a local shop cut these out tomorrow as well (I spent half the day trying to crank these rusted nuts off to no avail). What hardware do I need to have them save?
Also the white plastic band on the shock. Can I cut that off now or does it need to stay on while I'm installing them and then cut it off once they are installed?
Sorry if these are dumb questions but I've never installed shocks before.