[lxndr]

The frame for the back will not swap over because of the tilt release and pivot points. However, the foam in the back is the same for both sides.

The back foam in my drivers seat was broken down to where it was uncomfortable to sit in, so I went to the junk yard an yanked the foam out of a passenger side seat and later swapped it for my driverside foam. I should also mention that I am a professional upholsterer so I am familiar with how a seat is put together. Someone with no upholstery experience will have some difficulty doing this.



Yes I have a 1G, but I have '90 SI seats in it.