you have the pull the wood grain thing off in the middle of the dash. its not too hard, but will break easily. so go gentle. then the old radio is held in by two 7mm dolts i believe. take thos out and the old one can be pulled right out. next step would be to go to target and pick up the install kit. read in there how to put it together. it gives decent directions. the kit will come with a wire harness. black to black, red to red, green with a black strip to green with a black stripe. tape any that are not used. you will also need an antenna adapter. that is why i said get the install kit from target, all of this si included in the gm kit for only 15.99 i believe. whereas wall-mart sells the mounts for 9.99, the wire harness for 9.99, and the antenna adapter for 9.99. once your radio has all the mounts and the right harness instaled, it should plug straigt in, and bolt straight down where the old one came out of. pop the plastic wood grain back on and enjoy good tunes.