Quote:
|
Originally Posted by g8er065
I guess someone had to do it. I dropped an Isolator Bolt into the intake. Go ahead and laugh. I deserve it. Any suggestions???? Also I noticed the intake, butterflys and ports were very dirty. I cleaned out the ports, should I get some cleaner and clean the inside as well? 
|
Can you see it? a flexible "grabber" may allow you to get to it and pull it out. I am not sure if a magnetic one will work. Maybe a shop vac can help. Worst case is that you may have to remove the lower intake.
I cleaned the butterflys whan I have mine apart. May sure you use sensor safe solvents. If you can suck using a shop-vac while you clean you will prevent crud from getting into the cylinders