[drvngstorm05]

impossible, you can't fit an entire 3 inch pipe through our ground effects... if you look to see where they attach to, there is body there, they don't extend but MAYBE and inch and a half below the lowest part of the body... if you tried to put the entire exit within the ground effects you would also have to cut the body, which is not good. plus having it inside runs the risk of maybe cooking the plastic... the point of scraping wouldn't be on the sides anyway... it would be underneath the car that it would, and unless you want to beat up the floor pan, if not then you can't do anything about that... you can't have the exhaust right up against the floor either, there needs to be some space... running exhaust underneath like that will greatly increase the chance of scrapping... there aint much you can do about it... we have low cars... if you use any pipe larger than 2 and a half you will have real issues... if you want it to look clean then maybe you can trim the bottom edge of the effects in like a half circle shape and bring up the exhaust so the top part fits into the effects... that would be possible i suppose. you'll still have scrapping issues underneath the car however...