[Crasen]

if your brake fluid is not low and your brakes are operating normally you probably have a anti lock brake malfunction. If the anti lock brake Control Module detects a malfunction it will store a code and turn the light on. If you remove the negative battery cable for a few minutes or disconnect the control module (next to master cylinger) it should reset the code. If the light returns you have some sort of problem. Sometimes in the winter it will come on if you are driving through snow with your tires spinning and hit the brakes. You can get the trouble code by using a jumper wire jumper terminal H and A. H is on the bottom row, anf the second terminal from the left. A is on the top row and is the first terminal on the right. turn the key to run position and the light will flash to give you a trouble code. If I rememebr correctly you count the flashes and add the two number up to get the code as opposed to them being the digits of the number, I am sure if you get the code someone on here can help you out further, However i would try reseting it first