Quote:
|
Originally Posted by spatki1
... the CramShaft Position sesor which is suppose to take 180 degree angle ...
|
Ask stealership service about the error code: ECU gives error code P0340 for Camshaft pos sensor problem.
One of the problems here is that Nissan Service manual says that this sensor is not where you are been told, -but- in the front!!! ...and readily accessible. Hmm??? Check out yourself FSM page EC-205. Ask stealership service politely why the manual tells like this. (I know there are cars with campos sensors located as you have been told, and may cause this, I am just wondering why Nissan -97 Manual doesnt say so)
[edit: if u meant cranckshaft pos, its sensor is readily accessible from front, 15min swap time, see page 204]
Unplug this sensor connector, car should start in 'ECU limp -mode' =2200rpm limit. If not, there exists some other problems, also. Ask if this has been tested by service guys.
Ask quotation from your engine repair guy for this sensor swap.
---------------------------------------------------------------
Smtg else:
Theres one reasonably priced widget I'd buy, tells the codes, no installation needed, just push in the tst connector and you will get lots info: check out
http://www.scangauge.com/ This may be used in cars you'll possibly buy later, so the 'investment' is not in vain like the money thrown to stealership.
Check out your Private Message:
.