|
The driveshaft seal on the tranny can be changed without taking the tranny out. Just remove the driveshaft and the seal can be pulled with a regular seal puller. There is only one seal. However, you will need a seal installer to install the new seal - I have a kent more seal installer for this tranny - picked it up on ebay for a few $$ - it is specifically for this tranny but a standard seal installer may work. I'm not sure if you can buy the seal as a single item - I bought a gasket packet for the tranny when I rebuilt my tranny and it has all the replacement seals. Cost about $40 for the pack. Once you get the driveshaft out it should not be a difficult job.
However, the driveshaft into the tranny end should snap out (you will need a prybar or something similar) - if it just easily pulls out something is not right.
|