[paulsantangelo]

Ok, you asked, but I have information on a 92 rodeo, but it may be the same, I do not know.

I'm repeating this right from my workshop manual for a 92 rodeo.

The RWAL system contains 13 diagnostic codes which make the system troubleshooting straightforward. Momentarily grounding the rwal diagnosic lead (orange) with the read antilocking light on, will cause the light to flash out a diagnosis code if a shutdown has been detected and is in memory.

Count the number of of short flashes starting from the long flash. Include the long flash as a count. Sometimes the first count sequence is short because the flashout started with the count already in progess. Subsequently counts, however, will be accurate. If there is more than one system failure, only the first reconized diagnostic code will be retained in memory and flashed.

If a diagnstic code cannot be obtained and any of the following light conditions are observed:rear antilock light off but no two second bulb self check, brake light on and rear antilock light off, both rear antilock and brake light on or flashing.

The charts are too big for me to retype. Please get me this info and I'll get you the explanations.

Hope this helps!!