View Single Post
Old 12-06-2005, 12:11 PM   #5
larrybir24
AF Newbie
Thread starter
 
Join Date: Sep 2005
Location: Newport, Minnesota
Posts: 23
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Re: Which Heads to use on a SBC

[quote=71NOVA02]no problem. Good luck with the build this winter. What do you plan to do?

i turning my car into a real street car and i just put a ford 9in in couple weekends ago with 4:11 gears 28 spline moser axles, also with traction bars , also disc brakes all around, but now im putting a new floor in the car. then i will put the roll cage and racing seats and belts in later on this winter. While im doing that i will be building a 383 stroker motor with about 12.1 comp. eagle 4340 crank, h-beam rods, je forged pistons, proly dart heads 2.05's 1.60 or omthin an edlebrock air gap intake with a king demon carb. electric water pump and such i was told with some where around that combination it should make around 600+ hp. which the cr should run low 10's i hope but will see. But if you find anything else out about heads just let me know.

Dan
larrybir24 is offline   Reply With Quote