1.) Pry out from rear edge of sail panel (the triangular piece of trim by the window) to release 2 retaining clips, and remove panel.
2.) Pry off screw cover in door release trim (the trim surrounding the door opening latch) and remove 1 phillips (or Torx T20 screw.) Starting at the front edge, pry door release trim to release 2 plastic clips and pull forward toward rear of vehicle to release 1 plastic clip. Disconnect wiring harness (if equipped). Remove trim.
3.) Insert a small, flat blade screwdirver into bottom edge of door pull trim (the trim on the door pull). Pry out trim, grab and pull trim to remove.
4.) Remove 2 phillips screws (1/4" in some models) exposed by door pull trim removal.
5.) Remove 6 Torx T15 (or Torx T20) screws from edges of sides and bottom of door panel.
6.) If equipped with manual windows: With the window crank in the down postion, use a shop rag with a "shoeshine" motion to release "C" clip on rear of window crank and remove crank. You need to get the rag between the base of the handle and the plastic gasket for it to work. (Use some muscle...this is not an easy task.)
__________________
We the willing, led by the unknowing, are doing the impossible for the ungrateful. We have done so much, with so little, for so long, we are now qualified to do anything with nothing.
|