Hey folks:
Just swtiched out my rear pads and front sway bar bushings (thanks GirlBear for the photos and step by steps). Also cleaned out my MAF and did a tune up (plugs, wires, air cleaner, rotor, cap, oil change, tranny flush, PCV and fuel filter).
Has anyone here done a rear sway bar bushing swap, and if so how did it go? The front went really easy - with the use of a sawsall to cut the old bolts out. I noticed a vast improvement in the handling, but it still isn't perfect, I will be doing the inner and outer tie rod ends next week.
Thanx all,
bill