[vxtruong]

I recently bought a remote off Ebay, but it didn't come with instructions. If anyone has the instruction, please post it. Thanks.

I tried the 2000 Avalon instruction posted by Oldtheoden, the system is responsive but only up to the pressing buttons part. I don't think i have tne RS32000 system as it doesn't respond to it.

Programming: (2000 model supposedly)

1)Driver's door open, all other doors closed, key removed from ignition
switch.

2)Insert key into ignition switch, then remove it.

3)Press LOCK and UNLOCK on the vehicle door lock control switch at 1 second
intervals 5 times.

4)Close and re-open driver's door.

5)Press LOCK and UNLOCK on the vehicle dorr lock control switch at 1 second
intervals 5 times.

6)Insert key into ignition switch.

7)Switch ignition ON and OFF once to program a remote transmitter code
whilst retaining the original codes or twice to program a remote transmitter
code whilst erasing the original codes. Three times to check how many
remote transmitters are currently registered or five times to erase all
registered codes.

8)Remove key from ignition switch:
a)System should now lock unlock vehicle. Once , twice or five times
depending which mode has been selected. One to four times, slowly to
indicate number of remote transmitters registered.

9)Press and hold remote transmitter LOCK and UNLOCK buttons, together.

10)Press LOCK remote button for 1 second:
a)System should now lock and unlock vehicle once to confirm, twice to
indicate registration has failed.

11)If required repeat button procedure to program remaining remote
transmitters.

NOTE: To exit programming mode: Close driver's door or insert ignition key.

NOTE: A maximum of 4 remote transmitters can be programmed.