[p9o1r1sche]

When dipping a windshield in Future, I have held the part by the edge (if it is still on a sprue, it works well). Dipped it in the Future, then touched the bottom edge on a paper towel to let the excess wick off the part, then layed the windshield so it is flat. You will see there are areas where the Future is still thicker than other areas, but dont let that worry you. Future will dry to a very thin layer, so the differences in thickness is not an issue. At first, it may look like crap, but dont panic until you see what it looks like the next day. Again, it may take a little practice to learn the best method.

When I have sprayed it, I have thinned it with about one part denatured alcohol to two parts Future. You still have to be careful not to put too much on at once or it runs.