Quote:
|
Originally Posted by danfman
I did that job last year. You can borrow the a hub socket set from any autozone or larger auto parts store. You will also need a 3-jawed chuck after all the bolts have been removed to pullthe hub off the spline. Good luck
|
Nah... Simply run the nut up flush to the top of the axel and whack it a couple of times with a hammer..(don't worry, the threads will be fine)...
Then when you remove the 3 18mm bolts on the back of the knuckle, simply use a hammer tapping repeatedly on each side evenly (whack twice, go opposite end whack twice again, repeat as needed) the hub assembly will start to seperate from the knuckle...