[quickywd01]

You can use the wire thats there attached to the etacs which is taped up or hanging down just uplug it, its metal with a clear plastic over it. If you have any trouble or questions ask.
Programming a new remote:
1.Plug a programming valet switch (p/n 00243-16130) into the white and black wires. If you don't have a valet switch, just tap the black and white wires together to count as a "flick".
2.Turn on the ignition and flick the programming switch on/off 13 times.
3.Press button 1 on the remote.
4.Turn off the ignition. Press button 1. If the doors lock/unlock continue to step 5. If not, repeat steps 2-4.
5.Turn on the ignition and flick the programming switch on/off 14 times.
6.Press button 2 on the remote.
7.Turn off the ignition. Press button 1. The driver's door should unlock (if it locked, press button 1 again to unlock). Then press button 2. All other doors should unlock. If not, repeat steps 5-7.
Remove the programming switch and leave the white and black wires disconnected.