[gmcuajo]

You can connect the angel eyes to the position light; it will allow you to turn on the angel eyes with the parking lights.

When isntall the angel eyes:
DON'T CUT THE ANGEL EYES WIRES.

The angel eyes are a different type of light, and you should not cut the wires nomatter if them are too long.

Again step by step:
If you already install the headlights and not the angel eyes wires you can connect them through the fender.

1. For the left side, turn the steering wheel to the right or take out the wheel (if you have big wheels).
2. Remove the front of the "fender inner liner" by taking out some plastic clips.
3. Be sure your lights are off. Disconnect the position light (The lower small light on the corner of the headlight with two wires).
4. Untape it. DO NOT CUT ANY WIRE. Remove the plastic cover of the wire (the insulation) but without cutting the wires.
5. Connect the negative and positive of the angel eyes to the wires, respectively.
6. Be sure that you insulate it properly with electrical tape.

"I did it with my own 01 civic LX."