Quote:
|
Originally Posted by TheSilentChamber
Pickle joint seperates ball joints, not removes hubs. And if you rent from autozone or o'rielies you get your deposit back in full when you return it.
|
i'll tell you you really don't need pickle fork..but when you take the 2 bolt's out of strut that connects to hub..ok then take your bottom balljoint bolt out and you take little hammer if you do need to break it loose then you need a bar to pry down on lower control arm this will let your hub loose from everything you need to get hub off..and if you haven't got tierod loose yet smack rite beside where knuckle go's threw hole that is connected to hub.. now you do all that and knock axle loose.. it don't take much on axle to when you hit it you should have hole hub rite in your hand...i hope i exsplained it good enough anyway hope so?? let me know if you have any problems i do this day in and day out...
good luck to ya......
RICK..........