|
Re: clutch won't engage
CB,
Have you checked the clutch master cylinder for fluid level and leaks? That would be the first area to look. You probably have a hydraulic problem. After confirming the clutch master cylinder is full look at the clutch slave cylinder under the car on the right side near the rear of the engine. You will see the push rod connected to the clutch operating lever. Look for leaks around the slave cylinder push rod, this is a common area for leaks.
If it looks ok, have an assistant operate the clutch pedal while you observe the push rod. If it is operating correctly it should travel about 1/2" with the clutch pedal depressed to the floor. If it moves less than 3/8" you probably need to rebuild or replace one or both cylinders. Usually I have found the slave cylinders pitted, if it is a rebuild will not hold. It would be a good idea to replace the flexible hose at the same time the cylinders are repaired. Do the job right and it should last 10-12 years. If you decide to rebuild or replace the cylinders, remember you will need to bleed the system after it is filled with fluid. If you have additional questions post again. Do you have a Haynes or some other MGB repair manual? Hope this helps.
Clifton
|