|
I bought a new switch for my 91 a few years ago, and then found that the switch was OK! the switch is actually near the base of the column and is controlled by a rod that runs thru the column and connects to your control handle. The switch can work loose a bit and the rod won't quite open/close the circuit, so you might be able to just pull back a bit and tighten. It is kind of cramped under there but be patient. Might have to remove a panel under there, I don't remember, but if you have a good light and are patient, it won't be tough. Look under there with a light and move the control handle, you will see it.
__________________
I used to be indecisive, now I am not so sure.
|