I just looked at the service manual yesterday (for 5th gen) for that exact procedure (there is a rattle in my pass door, probably from the numerous slim-jim invasions; I've been locked out twice). It showed in detail the locations of all the screws, and more importantly the pop fasteners (of which there are a number, of different types), as well as the order in which to remove them. If you're serious about doing your own work, you should think about buying the service manual - it is complete, and will save you some major $, as well as headaches. I ordered mine from
www.helminc.com. I forget what it cost, but you can check it out. It'll tell you any tools you need, as well as the exact type of all the fasteners, so you can replace them as needed for a stock fit and finish (otherwise it may not go back on quite like it was). Aside from that, I can tell you there was a step where you needed to carefully lift the panel up to release it (just so you don't go pulling too hard and break anything). Good luck with it....... the manual is in my apt in CA, and I'm in VA right now, otherwise I'd be more specific.