Make sure you take before and after photos....
1) Cover all rubber hoses, disc etc using cloth tape or making tape
2) Clean calipers using brake cleaner and a rag (to get most of the dust etc off) I also used 'Simple Green' for this.
3) Use a drill with steel wool attachment and steel brush to clean rust, dust etc off. I also used a Dremel with a similiar attachment for the tight areas.
4) Then use brake cleaner again, a thorough spray and leave to dry, about 15 mins
5) Mask up any extra areas that you might hit with the brush.
6) Mix the paint together ie hardener etc (Should provide approx 3 hrs before going off)
8) Using a small brush paint 2 or 3 coats. Do not paint pads or discs or any metal pins etc. Be carefull of drips.
9) I gave an extra coat on the areas that could be seen.
10) Leave 24 hrs to cure
If you have any questions just email me:
[email protected]