|
sounds like replacing the line is now the only option.
the line is inexpensive, and no, you would not have to make all the custom bends to follow the frame (just make sure you tie wrap and/or bolt up the line, as you don't want it dragging down the highway;
sparks+fuel=BAD) and chassis.
the lines will probably be about $3-7 depending on 16"-4' lengths, the tubing cutter about $2-3, and you can get a bender if you like, but if you have the old line out as a kind of template, you can pretty much 'pre-bend' your new line on the shop bench with wooden blocks, or in the vise (making, minute 15-30degree bends at a time).
|