[4G4D Store]

Guys - as most of you know I'm working on a custom turbo setup that is leaving the a/c on the car. Right now I am at the dilemma of trying to figure out the best way to move the turbo towards the passengers side a few inches. But when I do this, the turbo of course doesn't match up with the hf manifold that I have, so this is what I'm thinking of doing? See pictures - I want to make a pipe that does a complete 360 deg turn and move the turbo over a few inches without dropping it down too far. My only worry is that with this 10" of pipe the turbo isn't going to spool very quick. So my question is - will this still spool quickly, or should I work on a different design. When I say spool quickly I'm saying sooner than 3500rpm on a d16a6 motor. This is my daily drive and I would prefer to not have a lot of lag. I am running a 14b tdoh4 turbo - and only about 7-9lbs of boost.