Finally got to start the kit today.
Spent a while sanding molding lines off bits. Have started to put together a few bits for ease of assembly.
Hopefully start the painting of bits tomorrow.
Now for the "DONT DO THIS AT HOME" bit.
The rims are two piece and need to be glued together. Now the rims are to wide for the tyres
on the back and need to be sanded down a bit. You can't sand to much though as the rims are not very thick.
So i sanded them down as much as i could, but they still didn't look right.
I then decided to glue the outside rim to the tyre, and have the inner rim sticking out on the inside were you wont be able to see it.
The first attempt failed...so
out come the SUPERGLUE 
Put the glue on both pieces, some on the tyre and held it in place with my thumb untill it dried.
BUT.... the glue run through the rim onto my thumb and glued the rim to my thumb
30minutes later and missing some skin to the thumb, we parted company after soaking it in some cleaning stuff from my work.
I felt a right plonker walking around the house with this wheel stuck to my thumb
trying to get it off.
Just as well i was home by myself.