[tommysraceshop]

ok, here we go. Bought a 1989 4wd blazer. Body junk ran ok. Came across a perfect 92 blazer body that was smashed in the front. In a moment of temporary insanity, I decided to combine both to make one. The 1989 ran until about a week before I started the transfer. It wouldn't start. If I used starting fluid or poured gas into throttle body it would run until the fuel was used up. I thought it was a fuel pump so when I had both bodies off their frames, I swapped fuel pumps. I disconnect the wiring harness from the firewall of the 89 and put in on the 92. After the body transfer and the wiring connection, it still will not start. I have fuel, spark and will run just like before if I use starting fluid or gas. In my pursuit of this project, I have replaced: the throttle body and injectors, ecm, distributor, steering column(thought it had to do with the ignition or switches), and even the fuel pump relays. I have a chilton manual and have started to trace all wires. Right now I do have power to the throttle body injectors, but they are not pulsing. If I manually jumper the injectors, I can get them to spray. I have no patience or hair left. HELP ME!!!!!